9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
Case: Service and Repair
Gear Case
Differential Bearing Race
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Replacement
1. Remove the five screws of the seal holder and remove the seal holder.
-
Put the shims, screws and seal holder in a safe place.
2. Press out the bearing race, together with its shims and seal holder, using tools installing sleeve Tool No. 87 92 202 and sleeve tube tool No. 87 91
204, or equivalents.
NOTE: The bearing race is reinstalled later after the bearing preload has been measured, refer to Assembly From Units.
Input Shaft Bearing Race
