9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
8. Install tool screw press tool No. 87 91 261, or equivalent, and pull down until the fourth gear's pinion and gear wheels on the input and output
shafts are level with each other.
-
Cut off the tie strap and remove tool output shaft assembly tool.
9. Slightly lift the input shaft and install the reverse gear with its pinion and synchromesh.
-
The hole in the reverse shaft should be facing the channel in the clutch case.
10. Install the gear change mechanism in the clutch case with the first gear's fork in first gear's position on the gear change mechanism and push up the
sleeve towards the second gear's synchromesh position on the output shaft.
-
Push up the sleeve in the fourth gear's synchromesh position on the input shaft.
11. Install first-second gears' and third-fourth gears' forks in their sleeves. Turn and push the mechanism into place.
-
Disengage first gear by lifting up the fork with a screwdriver.
-
Insert the guide sleeves and install one of the screws.
