9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
12. Install the reverse gear lever with the two remaining screws.
-
Tighten the three screws (reverse gear lever and gear change mechanism share one screw) with a torque of 20-28 Nm (15-21 ft. lbs.).
NOTE:
^
The reverse gear lever's two screws are 20 and 50 mm long.
^
The longer 50 mm screw is shared by the reverse gear lever and the gear change mechanism.
CAUTION: The oil plate of the reverse gear lever should be installed under the edge of the gear change mechanism.
13. Install the fork on the reverse gear's sleeve.
-
Ensure that the reverse gear lever enters the grooves of the reverse gear fork.
-
Then push in the fork shaft.
-
Engage reverse gear on the gear change mechanism.
14. Place gear selector shaft in position, sparingly lubricated with Mobile Grease 57C or Shell Grease 1344 LIEP II, or equivalent.
NOTE: Turn the gear selector shaft with the bevelled hole facing upwards.
15. Thread in and install the carrier in place, push in the gear selector shaft and install the screw.
-
Tighten to a torque of 20-28 Nm (15-21 ft. lbs.).
