9000 Hatchback L4-2290cc 2.3L DOHC Turbo EFI (1994)
21. Install the fifth gear wheel on the output shaft.
-
Tap down the fifth gear wheel, if necessary, with a plastic hammer and the sleeve tube so that the screw press can be installed.
-
Use the screw press to pull down the gear wheel.
-
Install a new nut.
22. Install the fifth gear's pinion with its needle bearing, synchromesh, synchromesh hub and sleeve on the input shaft.
-
The stop heels of the baulk ring should be positioned over the holes in the hub.
-
It might be necessary to tap down the hub on to the input shaft's splines joint using the sleeve tube and a plastic hammer.
23. Install dial indicator tool No. 87 92 194 with stand tool No. 87 90 727, or equivalents.
-
Engage third gear and push down the fifth gear's sleeve to "lock" the gearbox.
-
Tighten the nut and measure alternately with the dial indicator until there is an axial play of 0.15-0.20 mm on the output shaft.
-
Use a short 8 mm screw in the sealing surface as a fixed point.
-
Lift out the fifth gear's sleeve.
CAUTION:
^
Do not lift directly below the teeth, insert the screwdriver properly
^
Do not forget to remove the 8 mm screw.