saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Lever Bushings|Page 3635 > < Lever Bushings|Page 3633
Page 2
background image

8. Release the safety wire on cars with airbags.
9. Unscrew the screw and push back the rear air duct.

10. Remove the clip for the front air duct from the heater housing and push it towards the bulkhead panel.
11. Remove the lever from the selector shaft.
12. Remove the four screws on the gear lever housing.

-

Lift out the gear lever housing.

13. Remove the three clips and remove the lever.

Installation

1. Press the gear lever into the gear lever housing.

-

Make sure the clips lock properly.

2. Secure the gear lever housing with the screws.

Lever Bushings|Page 3635 > < Lever Bushings|Page 3633