900 S Convertible L4-2290cc 2.3L DOHC EFI (1997)
13. Install the damper's lower retaining bolt (3). Tighten the bolt.
Tightening torque: 62 Nm (45.8 ft. lbs.).
Remove the jack or similar. Install the hub assembly on both sides. Tighten the nuts.
Tightening torque: 50 Nm (36.9 Lbs ft) + 30° + 15°.
IMPORTANT: Always install new nuts if the hub nuts have been slackened or removed as they are of self-locking type and should not be reused.
14. Install the hose connections in the holders and install the retaining clips.
15. Install the nut washers and mount the rear anti-roll bar. Tighten the bolts.
Tightening torque: 24 Nm (17.7 ft. lbs.).
16. Remove the plugs from the brake pipe connections and install the brake pipes on both sides (4).
17. Fix the cables to the spring link and plug in the speed sensor connectors on both sides.
18. Install the righthand brake cable to the holder and lever.
19. Install the lefthand brake cable to the equalizing sleeve, lever and holders.
20. Install the return springs on both sides.
21. Install the rear silencer (5).
22. Lower the car slightly and remove the brake clamp.
23. Bleed the brake system.
24. Install the wheels and lower the car to the floor.
