900 S Coupe L4-1985cc 2.0L DOHC Turbo EFI (1998)
Console: Service and Repair
To remove
The floor console must be loosened and moved slightly to the rear before the centre console can be removed.
1
Remove the right and left-hand side side panels by removing the retaining screws (one screw is located behind the glove compartment) and
pressing each part out of the centre console.
2
Cars with manual gearbox: Remove the gearbox gaiter with a screwdriver. The gaiter is fastened with clips.
Cars with manual gearbox: Remove the rim.
3
Cars with ACC: Press out the ACC module from the rear and unplug the connector.
4
Cars without ACC: Press out the heater control panel from the rear.
5
Detach the air distribution shaft from the air distribution control.
6
Unplug the connectors for the vent control lighting, fan speed, electrically heated rear window and air recirculation.
7
Detach the cable to the heater control on the valve control module. The cable is secured with an eye bolt and locked with a lock washer.
8
Remove the heater control panel.
9
Unplug all the connectors to the centre console.
10
Remove the expansion rivets that secure the console to the dashboard by pressing in the centre pin approx. 3 mm and pulling the rivet out. Use
Removal tool 84 71 179. (See Tools and Equipment)
11
Lift away the centre console.
To fit
