saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Seat Heater|Description and Operation > < Diagram Information and Instructions|Page 10907
Page 8
background image

8-pin connectors 

H8-2

Under the left-hand seat. 

H8-3

Under the right-hand seat.

33-pin connector

H33-1

Grey connector on the bracket below the left-hand A pillar.

Grounding Points

G14

Grounding point, left-hand front seat member, under the seat.

G24

Grounding point, right-hand front seat member, under the seat.

G34S

Grounding point, control module bracket (Signal) below the right-hand A pillar.

DESCRIPTION OF OPERATION

Both front seats of the car are electrically heated.

The heating pads are supplied with current from fuse 20 in main fuse board 22A. They are turned ON by means of switches 252 and 253.

Thermostats 64 then turn the heating pads ON and OFF until the switch is depressed again.

Thermostat 64 closes at about +14 ° and opens at about 28 °.

The heating pads in the seat are grounded to the corresponding front seat member (grounding points G14 and G24).

FAULT DIAGNOSIS HINTS

The heating pads will be operative when the ignition switch is in the Drive position.
1. Check that fuse 20 is intact and supplied with current.
2. Check the heating pads for continuity.
3. Check the connectors, wiring harness and ground connections.

Seat Heater|Description and Operation > < Diagram Information and Instructions|Page 10907