900 S Coupe L4-2290cc 2.3L DOHC (1995)
5. Unplug the oil level sensor connector and pull the cable out of its clamps.
6. Remove the protective plate and oil pan.
-
Do not remove the guide sleeve from the cylinder block.
-
Wipe off all surplus oil.
7. Remove the big-end bearing caps and install protective sleeves Tool No. 75 19 531, or equivalent over the studs.
-
Push the pistons and connecting rods out of the cylinders.
NOTE:
^
To ensure that the parts are refitted in their original positions, note the markings on the pistons and connecting rods.
^
Loosely install the bearing shells and caps back in position on their connecting rods so that each set is kept separately and the parts are not
mixed.
8. Remove the wrist pin circlips and drive out the wrist pins, using a rubber mallet and drift.
