900 S Sedan L4-2290cc 2.3L DOHC (1994)
Action:
1.
If an owner has received a campaign notice, first inspect the belt installed on the vehicle. If P/N 43 60 103 or 43 95 414 is installed, or if a part
number cannot be read, replace the belt using P/N 43 59 063.
Check your DCS On-Line Recall/Campaign Inquiry screen. If the car is not indicated as having been repaired previously, replace the belt.
To Remove:
2.
Disconnect the air cleaner and move it aside.
3.
Ease the tension on the belt tensioner using a ratchet handle extension, and insert a 6 mm drill in the hole as shown.
Important
Take great care to ensure that the belt tensioner does not break at its end position.
4.
Take the drive belt off the pulleys.
5.
Raise the car take off the right-hand front wheel, remove the cover and the drive belt.
To Refit:
1.
Fit the drive belt and check its position on all the pulleys.
2.
Fit the cover and the road wheel.
Tighten the wheel bolts:
Alloy wheels: 120 N-m (89 ft.lbs.).
Steel wheels: 89 N-m (65 ft.lbs.)
3.
Lower the car to the floor. Relieve the belt tensioner of strain, using a ratchet handle extension, and remove the drill.
4.
Fit the air cleaner.
5.
Start the engine and run it at idling speed for a short while. Then switch it off and check that the drive belt is correctly positioned.
Warranty Information:
