900 S Sedan V6-2498cc 2.5L DOHC (1995)
10.
Remove the bottom of the spoiler (left side lower cover).
11.
Cars with auxiliary air pump: remove the air pump assembly.
Fitting Vacuum Pump
1.
Fit the vacuum pump including the rubber bushing to the supplementary bracket (46 48 663).
2.
Install the rubber bushings (item 2, Figure 3) on the right side of the supplementary bracket before marking the hole location in the next step.
Otherwise, the hole in step 3 will be off by the thickness of the bushings.
3.
Hold the supplementary bracket against the rear side of the air pump bracket and mark the lower left hole. Drill a 7/64 in. (6.5 mm) hole in the air
pump bracket and apply anti-corrosive primer. See item 3, Figure 3.
4.
Remove the plastic cover nuts and the washer fluid reservoir securing screw. Insert the bracket (46 48 663) between the washer fluid reservoir and
the body flange.
5.
Using the two M6 locknuts, secure the pump and bracket assembly to the body.
6.
Resecure the washer fluid reservoir using the screw and plastic cover nuts.
7.
Fit the four rubber bushings (42 35 768) to the bracket (46 48 663).
8.
Fit the two assemblies together.
9.
Refit the whole assembly into the original location. See Figure 3.
10.
Reconnect the air pump harness. Use two cable ties (79 71 880) to secure the wires to the bracket.
11.
Fit the hose to the vacuum pump and secure with a hose clamp (79 74 009). Mount the vacuum pump on its bracket.
12.
Route the hose in front of the engine mount, into the engine compartment, and on towards the firewall along the power steering hoses up to the
ABS control module. Adjust the hose length as necessary at the connection to the check valve.
13.
Plug the wiring harness' white connector to the vacuum pump. See Figure 5 and refer to the caution below it.
14.
Replace the fender liner, the left-hand cover plate, the parking lamp, and the left front wheel.
15.
Lower the car.
Fitting Wiring Harnesses
