900 S Sedan V6-2498cc 2.5L DOHC (1995)
Turning torque 40 Nm (30 lbf ft).
Remove the upper locking tool.
3. Turn the engine over two revolutions until just before the zero mark and place the locking tool on the crankshaft. Carefully turn the crankshaft in
the direction of engine rotation until the arm rests against the coolant pump's flange and then tighten the arm. Fit setting tool 83 95 006 and check
that the markings on the camshaft sprockets are aligned with the markings in the tool.
Important
Check that the A marking is about 2 mm above the B marking, see illustration. If the distance is less than this, readjustment will be necessary.
4. Fit the crankshaft pulley.
Tightening torque 20 Nm (15 lbf ft).
5. Fit the cover and right-hand front wheel.
Tightening torques 110 Nm (81 lbf ft)
6. Fit the timing cover.
7. Refit the water pump pulley (to do this you will have to press the engine towards the left in the car - use the engine bracket as a fulcrum).
8. Refit the power steering pump pulley.
