900 S Sedan V6-2498cc 2.5L DOHC (1995)
INSTALLATION
1. Clean the joints.
2. Insert the front exhaust pipe and screw it on to the exhaust manifolds.
-
Use new seals, then tighten to: 40 Nm (30 ft. lbs.).
3. Screw together the joint under the car, then tighten to: 20 Nm (15 ft. lbs.).
4. Install the oxygen sensors.
-
Lubricate the thread with Molykote 1000, or equivalent prior to installing, then tighten to: 55 Nm (41 ft. lbs.).
NOTE:
^
The oxygen sensors are sensitive to blows and impacts and must be handled with care.
^
It is important that the connection between the oxygen sensors and the nipples is gas-tight.
5. Lower the car and reconnect the oxygen sensors cables. Install cable clamps and clips.
