900 S Sedan V6-2498cc 2.5L DOHC (1995)
-
Unless otherwise specified, all voltage measurements should be made with all components connected and with the ignition switch in the
DRIVE position.
-
Readings must be taken with a Breakout Box (BOB) connected between the control module and the control module connector.
-
Some readings are to be taken with the engine running at idling speed.
-
Several voltage levels must be regarded as guiding values. Your common sense should tell you whether a reading is correct or not.
-
If any test reading is obviously wrong, use the wiring diagram to trace the leads, connectors or components which you consider ought to be
checked more thoroughly.
NOTE: > greater than; < less than;
~/~ approximately equal to; ~ alternating current
Chart 1 of 4, Pins 1-7