900 S Sedan V6-2498cc 2.5L DOHC (1995)
S2000001-S2020094
S7010001-S7016141
Certain vehicles have already been corrected and have been excluded from this campaign. Be sure to check your DCS Recall Inquiry Screen before
beginning any work. If in doubt, the date code on the ECM may be checked. Date Code B02 indicates that the car has already been updated with the
correct ECM. No further work is necessary.
A warranty claim should be submitted even if only an inspection was made. This will ensure your payment for the work and update our recall records.
Recall Schedule:
Dealer Notification (DCS E-Mail)
April 5, 1995
Saab Press Release
April 17, 1995
PSI Bulletin issued
June 20, 1995
Owner Notification
June 30, 1995
Start of Repairs
July 15, 1995
Parts:
Engine Control Module
46 10 150
Rivet (Convertible model only)
79 72 490
(can be sourced locally if desired)
An initial parts order equal to 25% of the vehicles appearing on your Status List will be released automatically to you commencing the week of June 26,
1995. Additional quantities should be ordered using VOR ordering procedures. *Note no rivets were included in this shipment*.
Action:
1.
Remove the glovebox.
2.
Carefully pull back the carpet to expose the Motronic 2.10.3 ECM. See Figure 2.
3.
Inspect the date code on the ECM. B01 means the ECM must be replaced. B02 means that no further work is necessary. See Figure 1.
4.
If ECM replacement is necessary, detach and unplug the unit. On Convertibles it will be necessary to transfer the riveted bracket to the new ECM.
5.
Install a new P/N 46 10 150 ECM. Be sure that the connector is snugly fitted and re-install.
6.
Reinstall the glovebox.
Warranty Information:
When submitting a Recall 294 Campaign claim, the following information must be included on the claim:
Alternative 1: Inspection for date code only (no further action required)
