900 S Sedan V6-2498cc 2.5L DOHC (1995)
Installting
1. Position the selector lever housing sideways with its bottom facing to the left.
2. Plug in the rear connector and install the bush holding the wiring to the housing.
3. Insert the selector lever cable into its mounting and secure it with the circlip.
4. Straighten up the housing and position it properly in place.
5. Screw the selector lever housing in place.
6. Plug in the three connectors on the right-hand side of the housing.
7. Secure the wiring harness with 2 new clips and fasten the cable holder to the housing adjacent to the ignition switch.
8. Screw on the selector lever cable's front mounting point.
9. Move the selector lever and gear selector on the transmission to position N.
10. Adjust the position of the selector lever.
11. Install the indicator plate and its rubber seal in place. Make sure that the WINTER switch cable is properly inserted into the selector lever housing.
12. Refit the air ducts that were previously removed.
13. Install the floor and centre consoles.
14. Connect the battery.