900 S Sedan V6-2498cc 2.5L DOHC (1995)
Assembly
1. Check that 4th gear is locked with locking pin (with the ring uppermost) in the gearbox.
2. Place the gear lever housing with gear rod in the car and guide the gear rod into the bulk-head partition inlet.
3. Install the ignition lock's terminal.
4. Install the ignition lock's cables with two securing straps in the gear lever housing.
5. Install the gear lever housing with four screws.
6. Engage 4th gear and insert locking pin into the gear lever housing. The locking pin's ring should be down in the hole.
7. Tighten from above the nut on the clamp which holds the gear rod into the linkage on the gearbox to 19-23 Nm (13-17 ft. lbs.)
8. Remove the locking pin from the gearbox and install the plastic plug.
9. Remove the locking pin from the gear lever housing and try changing gear a few times.
10. Install the air duct.
11. Install middle console, middle console's side covers and front left seat.
12. Connect the battery's negative cable.
