900 SE Convertible L4-1985cc 2.0L DOHC Turbo EFI (1998)
Carrier Bearings: Service and Repair
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Removal
1. Place the differential in a screw vice with jaw protectors and pull out the bearings with puller tool No. 87 92 343, or equivalent.
-
Use sleeve tube tool No. 87 92 210, or equivalent, as a support.
Installation
1. Press the bearings down to the bottom with driver tool No. 87 91 311, or equivalent.
-
Use sleeve tube tool as support.
