900 SE Convertible L4-1985cc 2.0L DOHC Turbo EFI (1998)
Ring Gear: Service and Repair
Removal
-
Place the differential housing in a screw vice with jaw protectors.
-
Remove the final gear wheel's screws with external torx and tap out the final gear wheel with a plastic hammer.
Installation
1. Before reinstalling the final gear wheel, place it in water at a temperature of 50° C for about 10 minutes.
-
Tap the final gear wheel on to the differential housing with a plastic hammer.
2. Turn the final gear wheel so that the milled surface faces the flange of the differential housing.
-
Install new screws and tighten alternately.
-
Tightening torque: 60-70 Nm (47-55 ft. lbs.)