900 SE Convertible V6-2489cc 2.5L DOHC EFI (1997)
1
Open the battery cover and carefully remove the two batteries.
Important
Be careful not to touch the contact surfaces on the batteries as this may cause interruptions in operation.
2
Place a small screwdriver in the notch on the remote control and carefully pry apart the two halves.
Important
Be careful not to press the screwdriver into the remote control as this will damage the circuit board.
3
Detach the rubber button from the upper half with a small screwdriver.
4
Fit the new rubber button. Make sure the button symbols are in the correct positions.
Poke down the rubber with a small screwdriver. Check the front of the remote control to make sure it is correctly fitted.