900 SE Convertible V6-2489cc 2.5L DOHC EFI (1997)
Repair/Action code: 05
Labor Operation (US): 85211
Time: 0.4
(CA: C6010 L/side 0.4 hrs., C6011 P/side for 0.4
hrs.)
Procedure
The driver's seat has only one lever with a cable system, while the passenger seat has a lever on each side with separate cable systems. Make sure the
passenger back rest can be tipped forward using both levers.
The following directions are for fitting a cable spacer to the outside of the passenger seat but they can also be followed when fitting on the inside of the
passenger seat and on the driver's seat.
1
Remove the seat concerned from the car. See "8. Seats, Adjustment/replacement, Front seats".
2
Cut the staples securing the bottom of the backrest upholstery.
3
Release the two upholstery rods holding the front of the upholstery taut by bending out the metal tabs.