900 SE Convertible V6-2489cc 2.5L DOHC EFI (1997)
Pins 22-26
Remember:
-
Measurements should be taken directly from the electronic control module sensor connector. Remove the electronic control module connector.
-
A few voltage levels must be seen as standard value. Use sound reasoning when judging whether a measured reading is correct or not.
-
If any measurement value is incorrect, use the wiring diagram to find which conductor, connector or component requires further testing.
-
The side references on the table refer partly to the particular signals and partly to the fault diagnosis with a complete description of rectification
procedures.
-
If nothing else is indicated the ignition timing should be disconnected.
-
The test reading given concerns calibrated FLUKE 88/97.
NOTE: There is no BOB cable to ABS 5.3.
