900 SE Convertible V6-2489cc 2.5L DOHC EFI (1997)
Checking brake discs and wheel hubs
Refer to Service Manual 5:1 Brakes for checking the brake discs.
See below for checking wheel hubs.
1
Remove the wheel, brake caliper and brake disc.
2
Make sure the hub is clean and free from impurities. Only one dial is used. Make a recess in the tool as illustrated so that the wheel hub will not
make contact with the tool.
3
Rotate the hub and check the run-out (the value between the greatest and the smallest readings).
If run-out exceeds 0.03 mm, the hub must be replaced.
Important:
The dial will jump about 0.03-0.05 mm at each bolt hole. This is normal.
4
Fit the brake disc, brake caliper and wheel.
Tighten the wheel bolts with a torque wrench.
Tightening torque 120 Nm (89 lbf ft).