900 SE Convertible V6-2498cc 2.5L DOHC (1995)
Disengaging tailgate
Programming to be able to use the car key to disarm/unlock the tailgate.
Cannot be used for Theft alarm 900.
Programming For Siren
In the basic version, only the alarm's special horn is used for the sound alarm. However, in certain markets it is required that a siren with battery back-up
is fitted. The alarm horn is activated via a relay output in the electronic control module. This means that the horn is activated by being grounded. The
siren must be continuously supplied with 12 V, and if this is cut, the siren starts. In order to achieve this, the alarm must be programmed for the siren. In
order to function correctly, the siren must be selected in the "COUNTRY CODE" menu. See programming "COUNTRY CODE".
Programming
Connect the scan tool.
Select "PROGRAMMING".
Select "SIREN" and then:
1
"ON" if the siren is to be included.
2
"OFF" if the siren is not to be included.
Important: IF "ON" is selected, the sound confirmation not available.
Panic Alarm
The theft alarm has a programmable "panic function". This means that the alarm can be quickly set off using only the remote control if for instance an
attempted break-in is discovered.
-
The alarm is set off if the left-hand button on the remote control is held depressed for at least 2.25 sec.
-
The alarm is according to the country code selected.
-
Press the LH button again to switch off the panic alarm.
Programming
Connect the Intelligent Saab Tester (ISAT) scan tool.
Select "ADJUSTING"
