900 SE Convertible V6-2498cc 2.5L DOHC (1995)
5TH BOW MOTOR HIGH LIMIT: [ ] (reg. box)
Using these HIGH LIMITS, CALCULATE and RECORD as follows:
TONNEAU MOTOR HIGH LIMIT= value recorded above minus 5 [ ] (bold box)
5TH BOW MOTOR HIGH LIMIT= value recorded above minus 2 [ ] (bold box)
Transfer these two values to the chart on the last page.
10.
Lower the top completely using roof switch in the center console.
NOTE:
Make sure the switch is held for at least 3-5 seconds after it appears all top action has stopped. This will ensure TONNEAU latch operation has
been completed and programming can take place properly. The Tonneau Motor continues to move after the Tonneau is closed to pull the
cables that close the latches.
11.
Use the ACTIVATE menu on SAT to drive the MAIN MOTOR all the way down.
12.
Change SAT to READ VALUES and read MAIN MOTOR values.
Record the information for LOW LIMIT [ ] (reg. box)
CALCULATE MAIN MOTOR LOW LIMIT: value recorded above plus 1. [ ] (reg. box)
Transfer this value to the chart at the end of this bulletin.
NOTE:
Normally the OVERLAP values are fixed and should not need to be changed. If you encounter a problem with two moving components
coming into contact with each other, or if the rear window is contacting the rear seat headrest, these steps can be used to establish basic
OVERLAP LIMITS that will allow the top to function.
13.
To obtain OVERLAP values:
NOTE:
If any values change back and forth while you are reading them from ISAT for high limits select the lower of 2 numbers; for low limits select
the higher of 2 numbers.
MAIN MOTOR:
Press the roof switch in the center console forward until the top is lifted and the fabric edge of the 1st bow is 1 meter from the forward edge of the trunk
lid. See Figure.
Read and record value using ISAT.
This value equals the MAIN MOTOR OVERLAP HIGH LIMIT. [ ] (bold box)
CALCULATE MAIN MOTOR OVERLAP LOW LIMIT:
Main Motor Overlap High Limit recorded above minus 6. This value equals the MAIN MOTOR OVERLAP LOW LIMIT. [ ] (bold box)
5TH BOW MOTOR:
