900 SE Convertible V6-2498cc 2.5L DOHC (1995)
position
15.
The soft top cover latches must be checked and adjusted if necessary.
16.
Raise the soft top cover sufficiently for special latch adjusting tool 82 93 177 to be placed as illustrated.
17.
Make sure the soft top cover latch fitting goes freely into the latch without touching the tool. Listen for a "clicking" sound as the microswitch is
activated. The latch must be adjusted towards the front if it touches the tool.
18.
Adjustment
Undo the two nuts securing the latch and push it forwards. Tighten the nuts.
Return to step 17 and check the adjustment.
The soft top cover may "knock" on the latch when closing. If this is the case, lower the latch slightly so that the soft top cover rests on the seals,
19.
Fit the backrest cushion and rear side trim See "8. Convertible, Adjustment and replacement, Backrest cushion".
20.
Fit the side trim and floor mat in the luggage compartment. See "8. Convertible, Adjustment and replacement, Luggage compartment upholstery".
21.
Cycle the soft top to be sure it is functioning correctly.
22.
Connect the diagnostic tool, clear any trouble codes and then program the control module. See "8. Convertible, Fault diagnosis, General,
Programming control modules".
Warranty/Time Information
Failed Object: 81419
Fault/Reason code: 37
Location code: 0
Warranty type (US): 01
Repair/Action code: 01
Labor Operation (US): 81419 1.6 + 0.2 straight time
(CA: B3278 1.8)
PLEASE ADD THE FOLLOWING INFORMATION TO YOUR DCS TABLES:
FAILED PART TABLE:
FAILED OBJECT: 81419
DESCRIPTION: WIRE CV TOP
