900 SE Convertible V6-2498cc 2.5L DOHC (1995)
11.
Assemble the motor's aluminium plate, gearcase and spring with the new pin in the two angle brackets. Fit the circlips on the ends of the spindle.
12.
Fit the gearcase on the drive unit's plate bracket. Mark the position of the holes for the angle brackets in the drive unit's plate.
13.
Remove the gearcase. Center punch the marks and drill two holes with a 7.5 mm (19/64") bit.
14.
Fit the gearcase to the drive unit's plate and install the two angle brackets.
15.
If the drive unit's plate has a bracket for the connector, it must be bent to one side and backwards 10°, Fit the connector to the bracket. If there is
no bracket, the connector must be secured with cable ties.
16.
Make sure the catch works with the reinforcement kit fitted. The spring must be able to tilt out the motor once the catch has been released.
