900 SE Convertible V6-2498cc 2.5L DOHC (1995)
First check whether the motor cover panel is fined with two Torx screws (A) and that a plastic plug (B) and tape (C) are fitted to the cover panel. If the
bolts or plastic plug are not fined, proceed as described.
1.
Operate the top so that the fifth bow and Tonneau cover are fully up.
2.
Connect ISAT and move the fifth bow latch motor to the half-open position (access flaps in half-open position) using the ISAT commands:
"TSAS"
"ACTIVATE"
"LOCKING MOTOR 5th BOW"
"UP"
Important
This cannot be done unless you have previously changed the control module as described in SI 812-1566.