900 SE Convertible V6-2498cc 2.5L DOHC (1995)
29.
Fit the two threaded inserts into the Tonneau cover. These are fined into the holes above the fifth bow locking motor. Use Torx bolts with washers
and thread into the holes. Tighten to 3.4 Nm (2.20- 2.95 lbf ft) or until they stop against the Tonneau cover.
Important
On cars from chassis number V7003161, these threaded inserts are already fined.
30.
Check that the six clips holding the cover plate are correctly fined.
31.
Attach the foam to the flat section of the top of the motor.
32.
To mark the position of the hole on the cover plate, put a spot of paint or grease on the motor shaft. Press the cover lightly into the clips. Using a
center punch or awl, mark the position of the two holes to be drilled for the threaded inserts.
Press the cover lightly over the motor to mark the shaft position.
Remove the cover and check that the marks match the diagram.
Drill 2 x 6 mm holes for the threaded insert screws.
