900 SE Convertible V6-2498cc 2.5L DOHC (1995)
3.
Connections for the half-size vacuum pump relay and fuse; use adaptor harness 47 39 686. A micro relay is factory-fitted in position F1.
a.
Fit the micro relay socket into position F2. Make sure it is properly secured.
b.
Fit the Yellow/Red 1.0 wire to fuse no. 4 (fused side).
c.
Remove the Red 1.5 wire from fuse no. 2 (fog light) position 1 (unfused side).
d.
Refit this wire in contact housing (91 24 157) position 2.
e.
Connect the Red 1.5 wire from the split contact (41 17 560, stamped on the connector) to fuse no. 2 position 1 (unfused side).
f.
Remove the Brown 0.75 wire from fuse no. 10 (headlight wiper) on the unfused side.
g.
Refit the Brown 0.75 wire that came from fuse no. 10 in contact housing (91 24 157) position 1.
h.
Connect the split contact (41 70 560) Brown 0.75 wire to fuse 10 on the unfused side.
i.
Fit the Brown 0.5 wire (from the split contact) into the micro relay bracket (vacuum pump relay position 3).
j.
Connect the Red 1.0 wire (from the split-contact) to fuse no. 4 position 1 (unfused side).
k.
Plug the split contact (41 17 560) into the contact housing (91 24 157).
CAUTION
Reversing the connections for the vacuum pump harness will blow fuse # 4 and the pump will not operate. Make sure to install the black connector
(item 1, Figure 5) to the vacuum switch and the white connector to the pump (item 2, Figure 5).
1.
Route the vacuum pump harness through the fuse box outlet and fix with cable ties to the main harness on both sides of the outlet seal. Refit the
relay/fuse bracket in the fuse box.
2.
Route the vacuum switch wires (black connector) with the OE harness along on the fire wall to the switch location. Use three cable ties (79 71
864) to secure the harness in place.
3.
Route the vacuum pump wires (white connector) beneath the expansion tank, forward along the OE front harness to the left front turn signal
location, and further to the pump bracket location inside the left fender. Secure with three cable ties (79 71 864).
