900 SE Convertible V6-2498cc 2.5L DOHC (1995)
12. Install the rubber duct for the mass air flow sensor.
-
Install the engine covers.
13. Change the engine oil and oil filter.
-
Top up with coolant and check the system for leaks.
14. Check all oil and fluid levels and top up as necessary.
-
Make sure that the engine bay is clean.
15. Bleed the cooling system as follows:
-
Fill the system up to the MAX level.
-
Install the pressure cap, start the engine and warm it up (preferably at different rpm) until the radiator fan starts.
-
Remove the pressure cap and run the engine at varying rpm until the radiator fan starts three more times.
-
Switch off the engine and top up to the MAX level, if necessary.
16. Drive the car on the road and check all functions.