900 SE Convertible V6-2498cc 2.5L DOHC (1995)
1.
Join the two brackets with the rubber suspension block. See Figure 1, item A.
2.
Raise the car and remove the old holder. Scrap all bolts and washers.
3.
On the engine, clean the threads of the hole for the bolt at top left.
4.
Fit the new holder to the engine by means of three bolts. Do not tighten the bolts. See Figure 1, item B.
5.
Screw the holder to the exhaust pipe with the spacer between the holder and the catalytic converter. Before tightening, check that the rubber
suspension block is positioned vertically.
Tightening torque: 20 Nm (15 ft.lbs.).
6.
Tighten the bolts securing the holder to the engine.
Tightening torque: 20 Nm (15 ft.lbs.) Lower the car to the floor.
Warranty Information:
Based on a customer complaint, a warranty claim may be submitted using the following information:
Failure coding: 25230-31-1-01/06-01.
Time allowance is 0.3 hr. which should be entered as straight time.
