900 SE Convertible V6-2498cc 2.5L DOHC (1995)
17.
Fit the link arm to the drive unit.
18.
Fit the soft top cover drive unit, see "8. Convertible, Adjustment and replacement, Soft top cover motor".
19.
After fitting the reinforcement kit, the front soft top cover latches must be checked and adjusted as necessary.
20.
Raise the soft top cover until special tool 82 93 177 can be located as illustrated.
21.
Make sure the soft top cover latch striker goes freely into the latch without touching the tool. Listen for a "clicking" sound when the microswitch is
activated. If the latch striker touches the tool, the latch must be adjusted towards the front of the car.
22.
Adjustment:
Remove the relevant side trim. See "8. Convertible, Adjustment and replacement, Rear side trim".
Loosen the two nuts securing the latch and adjust the latch forwards. Tighten the nuts.
Return to step 21 and check the adjustment.
When being closed, the soft top cover can "knock" against the latch. In this is the case, adjust the latch slightly so that the seals buffer the soft top
cover.
Refit the rear side trim. See "8. Convertible, Adjustment and replacement, Rear side trim".
23.
Connect the diagnostic tool, clear any diagnostic trouble codes and then program the control module. See "6. Convertible, Fault diagnosis, general,
Programming the control module".
Warranty/Time Information
