900 SE Convertible V6-2498cc 2.5L DOHC (1995)
Read the temperature gauge in the car.
3
Plug in the BOB and connect a voltmeter:
Car equipped with main instrument display panel 1: Plug in the BOB and connect a voltmeter across pins 70 and 61 on the BOB.
Car equipped with main instrument display panel 2: Plug in the BOB and connect a voltmeter across pins 70 and 14 on the BOB.
Select "ACT. INSTR. FUNCT" and then "TEMP. GAUGE OUT 1" or "TEMP. GAUGE OUT 2" from the ISAT scan tool menu. The voltage
reading obtained should be:
about 0 V with the ignition switch "ON".
about 12 V with the ignition switch "OFF".
4
If the voltage readings are not OK, check the wiring for continuity/shorting as follows:
-
between pin 61 of the ICE module connector and pin 4 of the main instrument display panel connector (12p-1 main instrument display panel
1).
-
between pin 14 of the ICE module connector and pin 7 of the main instrument display panel (main instrument display panel 2).
