900 SE Convertible V6-2498cc 2.5L DOHC (1995)
7. Remove the four retaining nuts for the main throttle and TCS throttle. Withdraw the main throttle, remove the vacuum hoses and then move the
main throttle to one side.
8. Unplug the TCS throttle body connector. Lift away the TCS throttle body with the two gaskets. Pay attention to the orientation of the pattern of
holes in the outer gasket.
9. Remove the old gasket from the mating surfaces of the inlet manifold.
Installation
1. Clean the contact surfaces between the main throttle body, - the TCS throttle body - and the inlet manifold. Remove any gasket residue and clean
the mating surfaces of the inlet manifold.
2. Install a new inner gasket on the inlet manifold, install the TCS throttle body in position, and plug in the connector.
3. Install a new outer gasket on the TCS throttle body. Make sure that the pattern of holes is correctly oriented.