900 SE Convertible V6-2498cc 2.5L DOHC (1995)
14. Remove the belt roller by removing the rear bolt from the slide rail.
Installation
-
Installing is in reverse order. First install a new belt with belt tensioner and plug in the connector to the belt tensioner. Test using ISAT as follows.
-
Refit the negative battery lead, switch on the ignition and connect the ISAT to the data link connector under the facia. Erase any diagnostic trouble
codes.
-
Switch off the ignition and switch it back on again. Wait for at least 10 seconds with the ignition on.Check to see if any diagnostic trouble code is
displayed.
If a diagnostic trouble code is displayed:
Conduct appropriate fault diagnosis. See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview
If no diagnostic trouble code is displayed: Refit all removed parts.
Tightening Torques
Belt roller securing bolts: 45 Nm (33 ft lbs)
Adjusting plate securing bolt: 24 Nm (18 ft lbs)
Slide rail securing bolts: 45 Nm (33 ft lbs)
