900 SE Convertible V6-2498cc 2.5L DOHC (1995)
Ignition Lock: Service and Repair
Manual Transaxle
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
Disassembly
1. Remove gear lever housing.
2. Remove the locking plate holder.
3. Remove the spring that secures the locking plate.
4. Use a screwdriver to click up the rider which is controlled from the ignition lock.
-
Lift up the locking plate and its plastic fastener.
5. Remove the ignition lock switch.
6. Remove the ignition lock.