900 SE Convertible V6-2498cc 2.5L DOHC (1995)
INSTALLATION
1. Move the bulkhead seal and rubber bushes on the righthand and lefthand sides away from the valve body (replacement of steering gear only).
2
Disconnect the internal pipes from the steering gear and plug them (replacement only).
3
Lift the steering gear into place through the lefthand wheel housing.
4. Remove the plugs and connect the pipes to the valve body.
5. Remove the plugs and connect the delivery and return pipes (1). Use special tool 87 91 287.
6. Mount the fixing clamps on lefthand and righthand sides (2).
IMPORTANT: Note the cable holder on the righthand side.
7. Install the track rod to the steering swivel member and tighten the connection, using a torque wrench.
Tightening torque: 60 Nm (44.3 ft. lbs.).
8. Install both track rods to the steering gear and tighten the connections, using a torque wrench (3).
Tightening torque: 85 - 100 Nm (62.7 - 73.8 ft. lbs.).
