900 SE Convertible V6-2498cc 2.5L DOHC (1995)
14.
Fit the knee shield and the lower dashboard section. See Figure 7.
15.
Refit both stalk switches and the fixing cable.
16.
Turn the coil spring to the end position and then back 2.5 turns. See Figure 7.
17.
Fit the steering wheel and tighten the nut, using a torque wrench. Note the locating groove in the steering wheel mounting. See Figure 7.
Make sure the steering wheel is on straight.
Tightening torque: 22.1 ft.lbs. (30 Nm)
18.
Test drive and verify that steering is centered.
Warranty Information
When submitting a Recall 298 Campaign claim, the following information must be included on the claim:
Alternative 1: Inspection of steering column assembly only (no further action required)
Failure code:
10298-79-0-05-08
Labor operation: 10298 for 0.7 hr.
RAC = 1
Alternative 2: Inspection and replacement of steering column assembly
Failure code:
10298-79-0-05-01
Labor operation: 10298 for 0.7 hr.
Straight time:
0.8 hr., includes 0.2 hr. for test drive.
RAC = 3
The following information must be added to your DCS Table:
Failed Part:
10298
Description:
95 900 CV Steering Col. Recall
Operation No.:
10298
Description:
95 900 CV Strg.Col. Recall .7 hours
Trans. type:
B
Engine type:
9
Begin year:
95
End year:
95
NOTE:
If a rental car is necessary, please submit a claim using the following information:
Failure code: 11700-00-0-17-08
Enter amount to be claimed in sublet.
Enter DAC code.
NOTE:
Max. allowance for rental is 2 days. After that time DSPM would have to pre-approve with explanation provided in text.
You can add $7.00 for a car wash in sublet and topping off gasoline.