900 SE Convertible V6-2498cc 2.5L DOHC (1995)
Axle Shaft: Service and Repair
Righthand Side
IMPORTANT: Scrupulous cleanliness must be observed during all work on drive shafts and drive-shaft joints to prevent dust and dirt getting into the
joints. Before starting work, always clean the wheel arch, MacPherson strut and other areas round the drive shafts and joints.
NOTE: The numbers found below in parenthesis ( ), refer to that number (and that part/component) found in the illustration.
REMOVAL
1. Remove the dust cap and slacken the hub center nut (do not remove it completely).
2. Raise the car and remove the wheel.
3. Remove the hub center nut (1).
4. Remove the ball joint nut (2).
5. Remove the ball joint, using special tool 89 96 696 (3).
6. Unscrew the anti-roll bar nut (4). Collect the washer and rubber bush and press the spring link down.
7. Tap the drive shaft out of the hub, using a rubber mallet.
8. Move the MacPherson strut aside and withdraw the drive shaft. Take care to avoid stretching brake hoses and sensor cables.
9. Use special tool 89 96 654 to remove the driveshaft joint from the intermediate shaft.
