900 SE Convertible V6-2498cc 2.5L DOHC (1995)
Removal
1. Place the gear case in a press.
2. Press out the bearing race with driver tube tool No. 87 91 311, or equivalent.
Installation
-
Turn the case over and insert the bearing race using a plastic hammer.
-
Press in the new bearing race until stop with driver tool No. 87 90 800 and use tube tool No. 87 91 188, or equivalent, as support.
Selector Shaft Bushes
NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.
NOTE: The bushes for the selector shafts should be removed before cleaning the gear case. Certain detergents could destroy the bushes.
Removal
-
Using driver tool No. 87 91 238, or equivalent, carefully tap out the three bushes in the gear case and the bush for the selector shaft in the clutch
case.
