900 SE Convertible V6-2498cc 2.5L DOHC (1995)
4. Lift out the bearing support, reverse gear pinion, sleeve, baulk ring, wire coil, reverse gear wheel and needle bearing from the reverse gear shaft.
5. Check the condition of all parts as regards wear.
-
Replace damaged or defective parts.
-
Check the wear on the synchromesh by putting it in its correct place.
-
Measure with a feeler gauge in three places and calculate a mean value.
-
If the mean value is less than 0.5 mm, the synchromesh should be replaced.
Disassembly
NOTE: Lightly oil all parts with suitable 10W30 engine oil prior to installing.
1. Place the reverse gear shaft in a screw vice with protective jaw faces.
2. Install the needle bearing and reverse gear wheel on the shaft.
3. Install the baulk ring.
-
Check that the wire coil is installed on the synchromesh.
4. Install the synchromesh sleeve.
