900 SE Convertible V6-2498cc 2.5L DOHC (1995)
7.
If the support bar is twisted, straighten the support bar so that it is straight the whole way.
8.
If one or more of the spot welds are broken, fit a Pop rivet, part no. 82 35 178, in the hole in the support bar and fit a washer, part no. 70 88 073,
on the rear side and rivet together. The Pop rivet must fasten the support bar together with the reinforcement. If necessary a hole can also be
drilled into the upper section of the support bar and a second Pop rivet plus washer fitted there.
9.
Check the front support bar lower mounting.
The lower mounting for the door window front support bar has been moved back (by approx. 3 mm). This was done as a temporary solution by
grinding the adjustment hole from and including Vehicle Identification Number 27003542. The final solution involves the plate with the
adjustment hole being moved from and including Vehicle Identification Number 27004929. For cars after these Vehicle Identification Numbers,
check the support bar as per instructions in step 14 and proceed to step 15.
10.
Remove the lower mounting adjustment nut completely and screw in the adjustment screw. Carefully bend the support bar straight forwards.
