900 SE Hatchback L4-1985cc 2.0L DOHC Turbo EFI (1997)
Window Seal: All Technical Service Bulletins
Inside Front Door Window Seal - Comes Loose
SI No. 844-1784
PI No.
Date September 1997
Distr. all
900
Correcting Complaint that Internal Front Door Window Seal is Coming Loose
Background
The internal window seal on some cars can lift up a few mm at the rear edge. Follow the directions to rectify this complaint.
Parts
Screw (2): 7975535 (CA: 30509241)
Action
1.
Push down the door strip to the correction position. Remove the door panel.
2.
Lower the window.
3.
Protect the window from drilling damage by putting a putty knife (or something similar) between the internal window seal and the window.
4.
Drill a 2 mm hole approximately 10 mm (on 3-door) or approximately 55 mm (for convertible) from the rear of the internal window seal. See
Figure.
Drill through the seal and flange. See Figure.
5.
Fit the screw, P/N 79 75 535, in the hole (See Figure).
6.
Refit the door panel.
Warranty/time Information
To resolve a customer complaint for a vehicle in warranty, submit a claim using the information shown.
Failed object: 84422
Fault/reason: 07
Location: 3/4/5
