900 SE Hatchback L4-1985cc 2.0L DOHC Turbo EFI (1997)
3. Install the floor console over the handbrake. Do not press the console in to position, but let it remain unsecured.
4. Thread the connectors for the electric window module, the interior lighting and the rear seat heater through the hole for each unit.
5. Connect the electric window module connector and install the module.
6. Connect the interior lighting connector and install the switch.
7. Connect the rear seat heater connector and install the switch.
8. Tighten the floor console retaining bolts (2) and the retaining nuts (2).
9. Place the rear cover in position, making sure that the air duct is properly connected to the nozzle. Screw down the cover (1 torx).
10
Install the ashtray/cover.
11. Plug in the ignition switch lighting connector.
12. Install the ignition switch cover.
13. Refit the negative battery lead and switch on the ignition.
14. Connect the ISAT to the data link connector under the facia and erase any diagnostic trouble codes.
-
Switch off the ignition and switch it back on again.Wait for at least 10 seconds with the ignition on.
-
Check to see if a diagnostic trouble code is displayed.
-
If a diagnostic trouble code is displayed: Conduct the appropriate fault diagnosis. See: Restraint Systems/Air Bag Systems/Testing and
Inspection/Initial Inspection and Diagnostic Overview
-
If no diagnostic trouble code is displayed: Refit all parts that have been removed.
