900 SE Sedan L4-1985cc 2.0L DOHC Turbo EFI (1996)
9. Check that the brake piston is pressed back into the cylinder.
10. Install the brake caliper to the swivel member (5). 10 Install the wheel sensor (6).
11. Tighten the hub centre-nut slightly (7).
CAUTION: If the hub centre-nut has been slackened or removed, a new centre nut must always be fitted. This is because the locking device on
the nut will be less effective if the nut is refitted.
12. Install the wheel and tighten the five wheel bolts to 105 - 130 Nm (77.5 - 95.9 ft. lbs.).
13. Lower the car and tighten the hub centre nut when all four wheels of the car are on the floor (7) . Tightening torque: 290 Nm (214 ft. lbs.).
14. Tighten the nut at the top mounting (8), using a torque wrench to 90 Nm (66.4 ft. lbs.).
15. Pump the brake pedal to advance the brake pistons in the calipers.
