900 SE Sedan V6-2498cc 2.5L DOHC (1995)
242
Engine coolant level switch in the coolant expansion tank.
286
Outside temperature sensor, under the front bumper in the middle.
353
Radio/cassette player in centre of dashboard.
445
Data link connector under dashboard by the steering wheel.
(H16-1)
500
ICE on the relay holder located under the dashboard adjacent to the steering wheel.
509
Sensonic control module, in cabin on right-hand side of bulkhead partition.
522
"DEFECTIVE LAMP" indicator lamp in main instrument display panel 1.
540
Main instrument display panel on the dashboard.
541
SID unit in centre of dashboard.
544
"INFO DISPL" indicator lamp in main instrument display panel.
565
TSAS control module in luggage compartment on left-hand side.
10-pin connector
H10-2
On the bracket below the left-hand A pillar.
33-pin connectors
H33-1
Grey connector on bracket below the left-hand A pillar.
H33-2
Black connector on bracket below the left-hand A pillar.
Grounding Points
G30
Grounding point, left-hand structural member behind the battery.
G33P
Grounding point, connector bracket (Power) below the left-hand A pillar.
G33S
Grounding point, connector bracket (Signal) below the left-hand A pillar.
G34P
Grounding point, control module bracket (Power) below the right-hand A pillar.
G34S
Grounding point, control module bracket (Signal) below the right-hand A pillar.
DESCRIPTION OF OPERATION
There are three different versions of the SID unit in the dashboard, one for main instrument display panel 1 and two for main instrument display
panel 2 (with/without trip computer).
SID unit 1 incorporates:
^
Clock (analogue)
^
Outside temperature sensor
^
Light sensor (option)
^
Audio display (option) SID unit 2 incorporates:
^
Clock (analogue)
^
Outside temperature display
^
Light sensor
^
Audio display
^
CHECK functions
^
BLACK PANEL function
^
Trip computer SID unit 3 incorporates:
^
Clock (analogue and digital)
^
Outside temperature display
^
Light sensor
^
Audio display
^
CHECK functions
^
BLACK PANEL function
^
Trip computer (advanced)
Clock (Analogue)
All three versions of the SID unit incorporate an analogue clock.
The clock is set by means of the two buttons immediately below it. One of the buttons has a (+) function for putting the clock forward, the other
has a (-) function for putting the clock back.
Clock (Digital)
The digital clock in SID unit 3 is used by the trip computer for calculating the time of arrival and for time alarms.
Every time the analogue clock is adjusted, the digital clock will also be adjusted by the same amount (provided that the clocks have been
synchronized). The digital clock appears in the display during adjustment.