saab Workshop Repair Guides

Saab Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 10307 > < Diagram Information and Instructions|Page 10305
Page 4
background image

126

Motor, electrically adjustable door mirror, driver's side.

127

Motor, electrically adjustable door mirror, passenger side.

207

Heating elements in the door mirrors.

216

ACC control module in centre of dashboard.

500

ICE control module
LHD:above main relay board in dashboard
RHD:behind main relay board in dashboard

2-pin connector

H2-3

In the luggage compartment behind the left-hand wheel housing.

26-pin connectors

H26-1

Connector in driver's door, LHD

H26-2

Connector in passenger 5 door, LHD

H26-3

Connector in driver's door, RHD

H26-4

Connector in passenger 5 door, RHD 
33pin connector

H33-1

Grey connector on the bracket below the left-hand A pillar.

Grounding Points

G3

Grounding point, luggage compartment, below left-hand rear light cluster.

G24

Grounding point, right-hand front seat member, under the seat.

G35

Grounding point, dashboard, behind the connector bracket below the left-hand A pillar.

DESCRIPTION OF OPERATION

The electrically heated rear window and door mirrors can be switched ON and OFF by means of switch 116 on the heating and ventilation control
panel or via the automatic climate control unit.

At the same time as the electrically heated rear window is switched ON, current is also supplied to elements 207 in the electrically heated door
mirrors 126 and 127.

Current is supplied via fuse 1 to pin 30 of relay 113. When the ignition switch is in the Drive position, current is also supplied via fuse 21 to
spring-loaded switch 116.

When the switch is depressed, current is supplied to pin 66 of the Integrated Central Electronics (ICE) control module. The ICE control module
grounds pin 85 of the relay and the lamp in the switch is supplied with current at the same time.

From pin 87 of the relay the circuit is then connected to ground via electrically heated rear window 115 and the electrically heated door mirrors.

The ICE control module grounds the relay for 12 minutes and checks the battery voltage every 3 minutes. Should the battery voltage drop below
a certain level, the ICE control module will stop grounding the relay and so switch OFF the electrically heated rear window.

FAULT DIAGNOSIS HINTS

The electrically heated rear window and door mirrors are activated by turning the ignition switch to the Drive position.
1. Check that fuses 1 and 21 are intact and supplied with current.
2. Check connectors, wiring and ground connections.

Diagram Information and Instructions|Page 10307 > < Diagram Information and Instructions|Page 10305