900 SE Sedan V6-2498cc 2.5L DOHC (1995)
6. Install the ignition coil bracket and the ignition coil.
-
Plug in the camshaft position sensor connector and the oxygen sensor connector.
7. Install the coolant bridge, radiator hose and electric connectors and tighten to: 30 Nm (22 ft. lbs.).
8. Position a new gasket and install the lower section of the intake manifold.
-
Tighten the bolts in a circular sequence to: 20 Nm (15 ft. lbs.).
9. Install the centre intake manifold with fuel rail and tighten to: 20 Nm (15 ft. lbs.).
10. Install the fuel lines.
11. Install the intake manifold.
-
First install the following:
-
The hose to the EVAP canister purge valve.
-
The coolant hoses to the throttle body
-
The throttle connector
-
The Traction Control System (TCS) throttle body connector
-
The Idle Air Control (IAC) valve connector
-
The hose to the fuel pressure regulator.
NOTE: Make sure that the pressure regulator's vacuum hose is connected to the front nipple on the throttle housing (in front of the
butterfly).
-
Tighten all bolts at the mating surface.
-
Begin with the bolts in the middle and continue alternately towards the ends.
-
Tighten to: 20 Nm (15 ft. lbs.).