900 SE Sedan V6-2498cc 2.5L DOHC (1995)
9. Install the steering column shaft joint to the steering gear (4).
10. Remove the tape holding the steering wheel in position.
IMPORTANT: If the steering wheel has moved, the coil spring must be readjusted.
11. Refit the lower section of the dashboard.
12. Install the main fuse box.
13. Connect the ground (negative) cable to the battery.
14. Fill the hydraulic fluid reservoir with hydraulic fluid, start the engine and turn the steering wheel two or three times from full lock to full lock.
Switch off the engine and top up the fluid reservoir.
15. Install the road wheel and tighten the wheel bolts.
Tightening torque: 105 - 130 Nm (77.5 - 95.9 ft. lbs.).
16. Lower the car to the floor.
17. Check the toe-in and adjust if necessary.